We have found a lot of value in the Mini Educator from E-Collar Technologies for training and working with dogs. This video is solely to demonstrate how the remote and collar function, and does not go into any training techniques, strategies, or methods.
Turn on/off
• Remote: Hold On/Off button for 3 seconds.
• Collar: Touch red dot on remote to red dot on collar. Flashing green light means collar is on, momentary red light then no flashing means collar is off.
Front display
• Number in the middle of display: The current stimulation level.
• 1D on top of display: There is one dog collar attached to the remote.
• C on right side of display: Your remote is in continuous mode, which allows you to tap a button momentarily, or hold down a button continuously. Your dog will feel the stimulus for the duration that you finger is on the button up to ten seconds (safely lock will automatically stop stimulus after ten seconds).
Buttons
• Black S: This will be the primary button that you use. When you tap or hold this button, it will provide a stimulus at the level shown on the front display.
• Red S: This a boost button and will add 5 to the level shown on the display.
• Black T: This will provide a continuous vibrating sensation until the button is released (up to ten seconds).
• On/Off Light: In addition to turning the remote on and off (see above), pressing this button quickly will turn on the collar’s LCD light. One tap will make the light flash, two taps will make the light solid, and three taps will turn the light off.
• M/C: This will change the settings of the remote from continuous (C), to either momentary (M) or Momentary/Continuous (M/C). This will alter how the remote’s buttons function, so we recommend leaving this programmed to Continuous (C) mode.
Charging
• Collar: The light on the collar will flash continuously as long as the collar is on. A green light means that the collar has a full charge, orange means it have a few hours left, and red means an hour or less.
• Remote: The light on the remote will only flash when the display light is on. The same colors will flash to let you know the battery’s charge level.
• There is a dual charger included with your system, so that you can charge the remote and collar at the same time. It takes approximately two hours to fully charge.